Startnow Plastic Cable Drag Chain CNC Router Milling

The two ends of the shaft of the transverse diaphragm of this product are axial body structure, and the middle is a partition body structure and the upper pressure plate are just in line. After being pressed by screws, the water pipe, cable and oil pipe are formed through the hole. The composition of this mechanism solves the problem that there is no need to re-thread in each partition when the pipeline is replaced. At the same time, it also solves the problem that one section of the tow chain needs to be re-threaded when replaced after damage, and it is easy to disassemble and install. The towing chain of the utility model is not easy to be corroded, the towing chain itself is easy to be repaired, and the cable in the towing chain does not need to be re-threaded after the fault occurs, and the utility model is more convenient to use.

Structure

Drag Chain looks like the tank chain drg chain, consists of alot of link. Link is composed of the up and down or so four sections, each section can open, convenient installation, open the cover plate after put in the cable, tubing, the trachea, etc.

Material and Performance

Material: Reinforced nylon, good toughness and wear resistance, acid and alkali resistant ability.
Operating Life: Under normal use, up to 5 million reciprocating motion.

 Drag Chain Selection

High: Select the built-in cable, tubing, the trachea and conduit maximum height for reference, the height of the drag chain at least 10% of the remaining space.

Wide: Choose the built-in cable, tubing, trachea, the sum of its outer diameter for reference, the width of the drag chain at least 10% of the remaining space.